Sitemap | E-mail:[email protected]

ISO 1 chemical information,mechanical properties, physical properties, mechanical properties, heat treatment, and Micro structure, etc. It also contains the use of ISO 1

Location » Home » Grades > Stainless Steels > ISO 1

Contact

+86-13880247006

E-mail: [email protected]

ISO ISO 1

Profile

This page is mainly introduced the ISO 1 chemical information,mechanical properties, physical properties, mechanical properties, heat treatment, and Micro structure, etc. It also contains the use of ISO 1,such as it is commonly used in bars, sheet,plates, steel coils, steel pipes,forged and other materials application.
Stainless steels - Chemical composition

Steel Garde:ISO 1
Type:Stainless Steels
Country:International
Standard:ISO

Standard Number:

ITEM	Standard Number	Descriptions
1	ISO 15510 (2010)	Stainless steels -- Chemical composition
2	ISO 4955 (2005)	Heat-resistant steels
3	ISO/TS 15510 (2003)	Stainless steels - Chemical composition

Metallographic Structure:Ferrite
Application:Stainless steels - Chemical composition

Cross Reference Table(Equivalent Materials):

Material	Standard	Country
ISO 14	ISO	International
ISO 13	ISO	International
ISO 11	ISO	International
ISO 10N	ISO	International
ISO 10	ISO	International
ISO 17	ISO	International
ISO 15	ISO	International
ISO 16	ISO	International
ISO 19	ISO	International
ISO 19A	ISO	International
ISO 19N	ISO	International
ISO 19AN	ISO	International
ISO 1Ti	ISO	International

Chemical composition(mass fraction)(wt.%)

Elements	Min.（≥）	Max.（≤）
C		0.08
Si		1.00
Mn		1.00
P		0.040
S		0.030
Cr	10.50	14.00
Ni		0.75
Mo
N

Mechanical Properties

Tensile strength	205～711	σb/MPa
Yield Strength	268	σ 0.2 ≥/MPa
Elongation	11	δ5≥(％)
ψ	-	ψ≥(％)
Akv	-	Akv≥/J
HBS	431～101	-
HRC	30	-

Physical Properties

Thermal expansion	84-06	e-6/K
Thermal conductivity	96-07	W/m.K
Specific heat	450-460	J/kg.K
Melting temperature	7755-2067	째C
Density	3643-8770	kg/m³
Resistivity	0.50-0.60	Ohm.mm²/m

Heat Treatment Regime

Annealing	Quenching	Tempering	Normalizing	Q & T
√	√	√	√	√

Size Availability

Steel Grade	Specification	Processing range(mm)
ISO 1 Stainless Steels	Round Bar and Hollow Bar	Φ1 to Φ2000
	Square and Flat Steel	Φ10 to Φ100
	Plate and Sheet	0.08-800(Thickness)10-1500(Width)Length
	Tube or Pipe	OD:Φ4-410; WT:1-35 mm; Lenght:10-12000
	Coil and Strip Steel	THK:0.1mm Width:1500mm
	Forged	Ring/Cylindrical/Disk